This is the radio controlled, glow powered, 1/8 scale ready to run
Pro C-Hub Version Ofna Mutilator Truggy.

FEATURES: Chassis: 0.12" (3mm) thick aluminum hard coated kick up type
with front and rear nylon braces
Engine: .32 cu in (5.2cc) Ofna Force 32 (OFNG5208), pull start, slide
valve carburetor, foam air filter and glow plug
Exhaust: Polished aluminum tuned pipe and header
Radio: Ofna 2-channel AM transmitter and reciever
with SX-002 high torque servo and SX-001 standard servo
Radio Box: Low profile nylon fully enclosed box
Shocks: Four aluminum threaded oil filled shocks w/white springs,
0.16" (4mm) thick aluminum shock towers
Fuel Tank: 5.1oz (150cc) flip top siphon type Ttnk
Clutch: 3-shoe, constructed of nylon
Transmission: Single speed
Main Gear: 62T steel spur gear
Differentials: F&R fing and rinion w/bevel gears, center bevel gear
Brake: Two fiberglass brake disks
Tires: 5.5" (140mm) B-29 high traction race compound medium pin tires
Wheels: White dish type w/17mm hex adapters
Body: Pre-painted stadium truck body w/tribal flame designs and
heavy duty nylon racing wing
Caster: Front and rear adjustable, caster/toe-in refers to the angle
of the front suspension when viewed from the side of the car in
relation to the chassis
Camber: Front and rear adjustable, camber refers to the angle of the
tops of the tires from vertical when viewed from front or behind
vehicle
Suspension: C-Hub

INCLUDES: One Mutilator Truggy, assembled rolling Chassis, .32 size engine
w/recoil, pre-installed radio system w/high torque steering servo,
pre-painted body, pre-mounted tires on white dish wheels, aluminum
threaded shocks, instruction manual and decals, glow starter and
fuel bottle

REQUIRES: Radio Batteries: 12 AA size, 8 for transmitter and four for receiver
D size battery for the included glow starter
Fuel: 2-cycle glow fuel with 10%-15% nitromethane, 16% lubricant

SPECS: Length: 21.5" (546mm)
Width: 16.5" (419mm)
Height: 7" (178mm)
Weight: 9.5lbs (4309g)
Wheelbase: 14.5" (368mm)
Track: 13.5" (343mm)
Carburetor Needle Settings;
Master Needle Valve, 3-3-1/2 turns from closed
Low Speed Needle, Flush with ball end
Barrel Stop Screws (used to adjust idle) 1/16" gap

It is not possible to request a specific radio channel when ordering
because they are supplied by the manufacturer at random.